tlp3542 2014-09-22 1 toshiba photocoupler photo relay tlp3542 testers data recording equipments measurement equipments the toshiba tlp3542 consists of an aluminum gallium arsenide infrared emitting diode optically coupled to a photo-mos fet in a plastic dip package. the tlp3452 series are a bi-directional switch, which can replace mechanical relays in many applications. and its high on-state current maximum rating is suitable to control a power line. ? 6 pin dip (dip6) ? 1-form-a ? peak off-state voltage : 60 v (min) ? trigger led current : 3 ma (max) ? on-state current : 2.5 a (max) ? on-state resistance : 100 m (max) ? output capacitance : 600 pf (max) ? isolation voltage : 2500 vrms (min) pin configuration (top view) 1 : anode 2 : cathode 3 : n.c. 4 : drain d1 6 : drain d2 1 2 3 6 4 schematic 1 2 6 4 unit: mm jedec jeita toshiba 11 ? 7a9 weight: 0.4 g (typ.) start of commercial production 2003/07
tlp3542 2014-09-22 2 absolute maximum ratings (ta = 25c) characteristic symbol rating unit led forward current i f 30 ma forward current derating (ta 25c) i f /c ? 0.3 ma/c reverse voltage v r 5 v junction temperature t j 125 c detector off-state output terminal voltage v off 60 v on-state current i on 2.5 a on-state current derating(ta 40c) i on /c -22 ma/c junction temperature t j 125 c storage temperature range t stg ? 40~125 c operating temperature range t opr ? 20~85 c lead soldering temperature (10 s) t sol 260 c isolation voltage (ac, 1 minute, r.h. 60%) (note1) bv s 2500 vrms note: using continuously under heavy loads (e.g. the ap plication of high temperature/current/voltage and the significant change in temperature, etc.) may cause this pr oduct to decrease in the reliability significantly even if the operating conditions (i.e. operat ing temperature/current/voltage, etc.) are within the absolute maximum ratings. please design the appropriate reliability upon reviewing the toshiba semiconductor reliability handbook (?handling precautions?/?derating concept and methods?) and individual reliability data (i.e. reliability test report and estimated failure rate, etc). note 1: device considered a two-terminal device: pi ns 1, 2 and 3 shorted toget her, and pins 4 and 6 shorted together. recommended operating conditions characteristic symbol min typ. max unit supply voltage v dd ? ? 48 v forward current i f 10 ? 20 ma on-state current i on ? ? 2.5 a operating temperature t opr -20 ? 60 c note: recommended operating conditions are given as a design guideline to obtain expected performance of the device. additionally, each item is an independent guide line respectively. in developing designs using this product, please confirm specified characteristics shown in this document.
tlp3542 2014-09-22 3 individual electrical characteristics (ta = 25c) characteristic symbol test condition min typ. max unit led forward voltage v f i f = 10 ma 1.18 1.33 1.48 v reverse current i r v r = 5 v ? ? 10 a capacitance c t v = 0, f = 1 mhz ? 70 ? pf detector off-state current i off v off = 20 v ? 0.1 1.5 na v off = 60 v ? 1.0 10 na capacitance c off v = 0, f = 1 mhz ? 400 600 pf coupled electrical characteristics (ta = 25c) characteristic symbol test condition min typ. max unit trigger led current i ft i on = 1.0 a ? 1 3 ma return led current i fc i off = 10 a 0.1 ? ? ma on-state resistance r on i on = 2.0 a, i f = 10 ma, t = 10 ms ? 65 100 m isolation characteristics (ta = 25c) characteristic symbol test condition min typ. max unit capacitance input to output c s v s = 0 v, f = 1 mhz ? 0.8 ? pf isolation resistance r s v s = 500 v, r.h. 60% 5 10 10 10 14 ? isolation voltage bv s ac, 1 minute 2500 ? ? vrms ac, 1 second (in oil) ? 5000 ? dc, 1 minute (in oil) ? 5000 ? vdc switching characteristics (ta = 25c) characteristic symbol test condition min typ. max unit turn-on time t on r l = 200 (note 2) v dd = 20 v, i f = 5 ma ? 1.5 3.0 ms turn-off time t off ? 0.2 0.6 turn-on time t on r l = 200 (note 2) v dd = 20 v, i f = 10 ma ? 1.0 1.5 ms turn-off time t off ? 0.2 0.4 (note 2) : switching time test circuit v out i f t on t off 90% 10% 6 r l v dd v out 4 1 2 i f
tlp3542 2014-09-22 4 i f ta i on ta allowable forward current i f (ma) allowable on-sate current i on (a) ambient temperature ta ( c) ambient temperature ta ( c) i f v f i on v on forward current i f (ma) on-sate current i on (a) forward voltage v f (v) on-sate voltage v on (v) r on ta i ft ta on-sate resistance r on (m ? ) trigger led current i ft (ma) ambient temperature ta ( c) ambient temperature ta ( c) -20 0 20 40 60 80 100 120 0 10 20 30 40 50 -20 0 20 40 60 80 100 120 0 1 2 3 4 0.6 0.8 1 1.2 1.4 1.6 1.8 0.1 1 10 100 0.3 0.5 3 5 50 30 -150 -100 -50 0 50 100 150 -3 -2 -1 0 1 2 3 -20 0 20 40 60 80 100 0 50 100 150 200 -20 0 20 40 60 80 100 0 1 2 3 4 5 ta = 25 c ta = 2 5 c i f = 10 ma i on = 2 a i on = 2 a i f = 10 ma
tlp3542 2014-09-22 5 t on ,t off i f t on ,t off ta switching time t on ,t off (s) switching time t on ,t off (s) forward current i f (ma) ambient temperature ta ( c) i off ta off-state current i off (na) ambient temperature ta ( c) 0102030 100 1000 10000 300 3000 30000 30 -20 020 40 60 80 100 1000 10000 30 100 300 3000 30000 -20 0 20 40 60 80 100 1 10 100 1000 ta = 25 v dd = 20 v, r l = 200 ? t off t on t off t on v off = 60 v v dd = 20 v r l = 200 ? , i f = 5 ma
tlp3542 2014-09-22 6 restrictions on product use ? toshiba corporation, and its subsidiaries and affiliates (collectively "toshiba"), reserve the right to make changes to the in formation in this document, and related hardware, software and systems (collectively "product") without notice. ? this document and any information herein may not be reproduced without prior written permission from toshiba. even with toshiba's written permission, reproduction is permissible only if reproduction is without alteration/omission. ? though toshiba works continually to improve product's quality a nd reliability, product can malfunction or fail. customers are responsible for complying with safety standards and for pro viding adequate designs and safeguards for their hardware, software and systems which minimize risk and avoid situations in which a ma lfunction or failure of product could cause loss of human life, b odily injury or damage to property, including data loss or corruption. before customers use the product, create designs including the product, or incorporate the product into their own applications, customers mu st also refer to and comply with (a) the latest versions of all relevant toshiba information, including without limitation, this document, the specifications, the data sheets and application notes for product and the precautions and condi tions set forth in the "toshiba semiconductor reliability handbook" and (b) the instructio ns for the application with which the product will be used with or for. cu stomers are solely responsible for all aspects of their own product design or applications, including but not limited to (a) determini ng the appropriateness of the use of this product in such des ign or applications; (b) evaluating and determining t he applicability of any information cont ained in this document, or in charts, dia grams, programs, algorithms, sample application circuits, or any other referenced documents; and (c) validating all operating paramete rs for such designs and applications. toshiba assumes no liability for customers' product design or applications. ? product is neither intended nor warranted for use in equipments or systems that require extraordinarily high levels of quality and/or reliability, and/or a malfunction or failure of which may cause loss of human life, bodily injury, serious property damage and/or serious public impact ( " unintended use " ). except for specific applications as expressly st ated in this document, unintended use includes, without limitation, equipment used in nuclear facilities, equipment used in the aerospace industry, medical equipment, equipment used f or automobiles, trains, ships and other transportation, traffic si gnaling equipment, equipment used to control combustions or expl osions, safety devices, elevators and escalators, devices related to electric power, and equipment us ed in finance-related fields. if you use product for unintended use, toshiba assumes no liability for product. for details, please contact your toshiba sales representative. ? do not disassemble, analyze, reverse-engineer, alter, modify, translate or copy product, whether in whole or in part. ? product shall not be used for or incorporated into any products or systems whose manufacture, use, or sale is prohibited under any applicable laws or regulations. ? the information contained herein is present ed only as guidance for product use. no responsibility is assumed by toshiba for an y infringement of patents or any other intellectual property rights of third parties that may result from the use of product. no license to any intellectual property right is granted by this document, w hether express or implied, by estoppel or otherwise. ? absent a written signed agreement, except as provid ed in the relevant terms and conditions of sale for product, and to the maximum extent allowable by law, toshiba (1) assumes no liability whatsoever, including without limitation, indirect, co nsequential, special, or incidental damages or loss, including without limitation, loss of profit s, loss of opportunities, business interruption and loss of data, and (2) disclaims any and all express or implied warranties and conditions related to sale, use of product, or information, including warranties or conditions of merchantability, fitness for a particular purpose, accuracy of information, or noninfringement. ? gaas (gallium arsenide) is used in product. gaas is harmful to humans if consumed or absorbed, whether in the form of dust or vapor. handle with care and do not break, cut, crush, grind, d issolve chemically or otherwise expose gaas in product. ? do not use or otherwise make available product or related so ftware or technology for any m ilitary purposes, including without limitation, for the design, development, use, stockpiling or manufacturing of nuclear, chemical, or biological weapons or missile technolog y products (mass destruction weapons). product and related soft ware and technology may be controlled under the applicable export laws and regulations including, without limitation, the j apanese foreign exchange and foreign trade law and the u.s. export administration regulations. export and re-export of product or rela ted software or technology are strictly prohibited except in compliance with all applicable export laws and regulations. ? please contact your toshiba sales representative for details as to environmental matters such as the rohs compatibility of pro duct. please use product in compliance with all applicable laws and regula tions that regulate the inclusion or use of controlled subs tances, including without limitation, the eu rohs directive. toshiba assumes no liability for damages or losses occurring as a result of noncompliance with applicable laws and regulations.
|
